How Black Boxes Work

The widespread use of aviation recorders didn't begin until the post-World War II era. Since then, the recording medium of black boxes has evolved in order to log much more information about an aircraft's operation.

Older black boxes usedmagnetic tape, a technology that was first introduced in the 1960s. Magnetic tape works like anytape recorder. The Mylar tape is pulled across anelectromagnetichead, which leaves a bit of data on the tape. These days, black boxes usesolid-state memory boards, which came along in the 1990s.

Solid-state recorders are considered much more reliable than their magnetic-tape counterparts.Solid stateuses stacked arrays of memory chips, so they don't have moving parts. With no moving parts, there are fewer maintenance issues and a decreased chance of something breaking during a crash.

Data from both the CVR and FDR is stored on stackedmemory boardsinside thecrash-survivable memory unit(CSMU). The memory boards have enough digital storage space to accommodate two hours of audio data for CVRs and 25 hours of flight data for FDRs.

Airplanes are equipped with sensors that gather data such as acceleration, airspeed, altitude, flap settings, outside temperature, engine performance, and cabin temperature and pressure. Magnetic-tape recorders can track about 100 parameters, while solid-state recorders can track a lot more.

For instance, in the Boeing 787, the units can log a whopping 146,000 parameters, resulting in several terabytes of data for every single flight. That incredible load of data is a double-edge sword; it's great for monitoring the aircraft, but it can overwhelm engineers and maintenance personnel. To manage all of that data, they need sophisticated data management software.

Whether the system is an older version or fully modern, all of the data collected by the airplane's sensors is sent to theflight-data acquisition unit(FDAU) at the front of the aircraft. This device often is found in theelectronic equipment bayunder the cockpit. The flight-data acquisition unit is the middle manager of the entire data-recording process. It takes the information from the sensors and sends it on to the black boxes.

Both black boxes are powered by one of two power generators that draw their power from the plane's engines. One generator is a 28-volt DC power source, and the other is a 115-volt, 400-hertz (Hz) AC power source.

In almost every commercial aircraft, there are severalmicrophonesbuilt into the cockpit that listen to flight crew conversation. These microphones also track any ambient noise in the cockpit, such as switches being thrown or any knocks or thuds. There may be up to four microphones in the plane's cockpit, each connected to the cockpit voice recorder (CVR).

Microphones send audio to the CVR, which digitizes and stores the signals. In the cockpit, there is also a device called theassociated control unit, which provides pre-amplification for audio going to the CVR. The four microphones are place in the pilot's headset, co-pilot's headset, headset of a third crew member (if there is a third crew member) and near the center of thecockpit, to pick up audio alerts and other sounds.

Most magnetic-tape CVRs store the last 30 minutes of sound. They use a continuous loop of tape that completes a cycle every 30 minutes. As new material is recorded, the oldest material is replaced. CVRs that use solid-state storage can record two hours of audio. Similar to the magnetic-tape recorders, solid-state recorders also record over old material.

The flight data recorder (FDR) is designed to record the operatingdatafrom the plane's systems. There are sensors wired from various areas on the plane to the flight-data acquisition unit, which is wired to the FDR. So whenever the pilot flips a switch or twiddles a knob, the FDR records each action.

In the U.S., theFederal Aviation Administration(FAA) requires that commercial airlines record a minimum of 11 to 29 parameters, depending on the size of the aircraft. Magnetic-tape recorders have the potential to record up to 100 parameters. Solid-state FDRs can record hundreds or even thousands more.

On July 17, 1997, the FAA issued a Code of Federal Regulations that requires the recording of at least 88 parameters on aircraft manufactured after Aug. 19, 2002. Here are a few of the parameters recorded by most FDRs:

Solid-state recorders can track more parameters than magnetic tape because they allow for a faster data flow. Solid-state FDRs can store up to 25 hours of flight data. Each additional parameter recorded by the FDR gives investigators one more clue about the cause of an accident.

Airplane crashes are violent affairs. In many such accidents, the only devices that survive are thecrash-survivable memory units(CSMUs) of the flight data recorders and cockpit voice recorders. Typically, the rest of the recorders' chassis and inner components are mangled. The CSMU is a large cylinder that bolts onto the flat portion of the recorder. This device isengineeredto withstand extreme heat, jarring crashes and tons of pressure. In older magnetic-tape recorders, the CSMU is inside a rectangular box.

Using three layers of materials, the CSMU in a solid-state black box insulates and protects the stack of memory boards that store the digitized data.

Here's a closer look at the materials that provide a barrier for the memory boards, starting at the innermost barrier and working our way outward:

These hardened housings are incredibly important. Without adequate protection, all of the flight data would be destroyed. So to make sure that data stays safe, engineers attack their black boxes with full fury to see if their products can withstand extreme abuse.

To ensure the quality and survivability of black boxes, manufacturers thoroughly test the CSMUs. Remember, only the CSMU has to survive acrash— if accident investigators have that, they can retrieve the information they need. In order to test the unit, engineers load sample data onto the memory boards inside the CSMU. This pattern is reviewed on readout to determine if any of the data has been damaged by crash impact, fires or pressure.

There are several tests that make up the crash-survival sequence:

During the fire test, thememory interface cablethat attaches the memory boards to the circuit board is burned away. After the unit cools down, researchers take it apart and pull the memory module out. They restack the memory boards, install a new memory interface cable and attach the unit to a readout system to verify that all of the preloaded data is accounted for.

Black boxes are usually sold directly to and installed by theairplane制造商。黑盒都是安装在the tail of the plane — putting them in the back of the aircraft increases their chances of survival. The precise location of the recorders depends on the individual plane. Sometimes they are located in the ceiling of the galley, in the aft cargo hold or in the tail cone that covers the rear of the aircraft.

Although they are called "black boxes," aviation recorders are actually painted bright orange. This distinct color, along with the strips of reflective tape attached to the recorders' exteriors, help investigators locate the black boxes following an accident. These are especially helpful when a plane lands in the water. There are two possible origins of the termblack box: Some believe it's because early recorders were painted black, while others think it refers to the charring that occurs in post-accident fires.

In addition to the paint and reflective tape, black boxes are equipped with anunderwater locator beacon(ULB). If you look at the picture of a black box, you will almost always see a small, cylindrical object attached to one end of the device. While it doubles as a carrying handle, this cylinder is actually a beacon.

If a plane crashes into the water, the beacon sends out an ultrasonic pulse that cannot be heard by humanearsbut is readily detectable by sonar and acoustical locating equipment. There is asubmergence sensoron the side of the beacon that looks like a bull's-eye. When water touches this sensor, the beacon is activated.

The beacon sends out pulses at 37.5 kilohertz (kHz) and can transmit sound as deep as 14,000 feet (4,267 meters). Once the beacon begins pinging, it pings once per second for 30 days. This beacon is powered by abatterythat has a shelf life of six years. In rare instances, the beacon may get snapped off during a high-impact collision.

In the U.S. when investigators locate a black box, it's transported to the computer labs at theNational Transportation Safety Board(NTSB). Special care is taken in transporting these devices in order to avoid any further damage to the recording medium. In cases of water accidents, recorders are placed in a cooler of water to keep them from drying out.

After finding the black boxes, investigators take the recorders to a lab where they can download the data from the recorders and attempt to recreate the events of the accident. This process can take weeks or months to complete. In the United States, black box manufacturers supply the National Transportation Safety Board with the readout systems and software needed to do a full analysis of the recorders' stored data.

如果罗斯福没有损坏,调查人员可以simply play it back on the recorder by connecting it to a readout system. With solid-state recorders, investigators can extract stored data in a matter of minutes through USB or Ethernet ports. Very often, recorders retrieved from wreckage are dented or burned. In these cases, the memory boards are removed, cleaned up and have a new memory interface cable installed. Then the memory board is connected to a working recorder. This recorder has special software to facilitate the retrieval of data without the possibility of overwriting any of it.

A team of experts is usually brought in to interpret the recordings stored on a CVR. This group typically includes representatives from theairlineand airplane manufacturer, an NTSB transportation-safety specialist and an NTSB air-safety investigator. This group may also include a language specialist from theFBIand, if needed, an interpreter. This board attempts to interpret 30 minutes of words and sounds recorded by the CVR. This can be a painstaking process and may take weeks to complete.

Both the FDR and CVR are invaluable tools for any aircraft investigation. These are often the lone survivors of airplane accidents, and as such provide important clues to the cause that would be impossible to obtain any other way. Astechnologyevolves, black boxes will continue to play a tremendous role in accident investigations.

There are all sorts of potential improvements on the horizon for black box technology. Most obviously, current systems don't record any video of cockpit activity. For years, the National Transportation Safety Board has been trying in vain to implement video capabilities into black box systems, but many pilots steadfastly refuse to allow video, saying such systems violate their privacy and that current data capture is sufficient for accident investigators.

The NTSB continues to insist that there's no such thing as having too much information when investigating plane crashes. At present, video recording is still on hold.

But thetechnology不仅仅是准备好了。空中客车公司,例如,安装a Vision 1000 system in all of its helicopters. The Vision 1000 camera is mounted behind the pilot's head, where it records video of the pilot's actions and the cockpit area, as well as the view beyond the windshield, at four frames per second. It weighs about a half a pound and needs only power and a GPS connection for activation.

视频并不是唯一一个发现resi的改进stance from the status quo. Since 2002, some legislators have pushed for the Save Aviation and Flight Enhancement Act, which would require not one, but two flight recorders, including one that automatically ejects itself from the plane during an incident. Such self-ejecting recorders are easier to locate are less likely to suffer catastrophic damage. So far, though, the law has not passed Congress.

Black boxes aren't just for planes. They're now integrated into many types of vehicles. You may even have one in your car, though you don't know about it. About 90 percent of new cars have event data recorders (EDRs) that track the same kind of data as airplane black boxes. The EDR is ostensibly designed to maintain and monitor the car's safety system, but accident investigators can and do use EDR data to better understand wrecks ... and sometimes, to assign blame after an accident.

When it comes to black boxes mounted to airplanes, it's entirely possible that they'll go by the wayside. Instead of recording to a box, airplanes may soon simply stream all of their essential data directly to a ground-based station. These systems already exist. For example, AeroMechanical Services' FlyhtStream air-to-ground system sends flight data to a home base viasatellite.

Such systems eliminate the desperate search for a box that may have been destroyed in a crash, and may be more dependable, too. For the moment, though, black boxes are still very much a necessity each and every day as thousands of planes take to the skies, flying millions of people all over the world.