In the matter of a few hours, you can provide yourself with access to hundreds of digital channels. Follow the steps listed below and have your own, homemade digitalTVantenna in no time.
Materials:
Advertisement
- 21 ½-by-2 ½-inch wooden board
- 18 washers
- 20 screws
- 15 feet (457.2 centimeter) of wire
- Reflector Grid
- Balun
Tools:
- Wire cutters
- Drill
- Pliers
- Screwdriver
- Tape measure
- Pencil
Here's what to do.
- Mark the wooden boardYou will be making four sets of two holes, as follows: two holes 2 inches (5 centimeters) in from the edge of the board, and two more holes every 5 1/4 inches (13 centimeters) along the board [source:Current]. Using a measuring tape and pencil, mark your 21 ½-by-2 ½-inch wooden board where you will drill holes.
- Drill the holesDrill holes into the board using the pencil marks as your guide.
- Cut the wireUsing wire cutters, cut eight 17-inch (43.18-centimeter) pieces of wire. Bend the wires into "V's" with 7-inch (17.78- centimeter) sides and a 3-inch (7.62-centimeter) gap between the two legs of the "V."
- Attach the wires to the boardAttach the wire "V's" to the board with screws and washers, using a screwdriver.
- Zigzag the wire to attach the connectionsUsing more wire, connect the "V's." Coil the wire around the screws moving in a zigzag pattern across and down the board. Make sure the wires don't touch where they cross one another.
- Attach the reflectors确保反射器网格的董事会using screws and washers.
- Attach the BalunThe Balun has two wires with screw holes. Feed a screw through the holes. Secure the Balun to the zigzagged wire by screwing it into place. Make sure the wires don't touch where they cross one another [source:TV Antenna].
Advertisement